Concrete Stone Mold Release. Concrete release agent, Form oil, Form release G-1

Description

Release form concrete release agent, Mold release agent, Concrete form release agent
CONCENTRATED 30:1 FORMULA
Our Concrete Mold Release soluble concrete release agent will aid in releasing concrete or gypsum plaster castings from GlobMarble rubber molds. Release Agent provides a clean, positive concrete release and does not interfere with or affect surface detail and helps minimize air bubbles in finished castings.
Simplify Your Production Casting with G-1, GlobMarble Release
-      Low Cost
-      Non-Petroleum Based, Eco-Friendly
-      Economical - Mix With Water
-      Will Not Stain Concrete
-      Will Not Affect color surface detail or finishing
-      Minimizes “Bug Holes” In Concrete And Air Bubbles In Gypsum Castings
-      Contains No Oils that will cause rubber molds to soften, shrink or swell.
-      Keeps Molds Clean - Does Not Build Up
-      Significantly Extends GlobMarble’s Mold Life
Preparation
. Safety - Wear safety glasses to minimize contamination risk. Store and use at room temperature (73°F/23°C). Do not use below 45°F/8°C.
Pre-Mixing
- Before dispensing, shake container or stir thoroughly with a paddle or drill mixer set on a slow speed to a uniform consistency.
Diluting.
Concrete Mold Release can be used straight or diluted with 30 parts clean water. The dilution ratio depends on your concrete mix design.
Mix the solution at medium speed for 2 minutes.
Mix only amount needed for one day. Mixture may separate in the container after a few hours. Before dispensing, pre-mix before to a uniform consistency.
Application
– Apply GlobMarble Concrete Release Agent on a mold surface with a brush, roller, HVLP gun or
Non-Aerosol Sprayer
for G-1 Release  with a very thin film (.0005 in / .013 mm). Do not allow release agent to pool in the mold. Wipe over mold surface using a clean, soft cloth.
Caution: Do Not Over Apply
.
Applying too much concrete release agent will cause air bubbles “wormtracks”, “bugholes” or pitting on surfaces.
After applying release agent to mold surface, you can mix and cast concrete immediately. Mix only amount needed for one day. Mixture may separate after 24 hours. Re-mix to a uniform consistency and apply.
Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.
32 FL.OZ.  (946 ml) Bottle, Makes 7 3/4 Gal (29.3L)
To see my other items please visit
GlobMarble eBay Store
If you'll order more than 1 item, post charges will be combined automatically by Ebay shipping calculator
ATTENTION INTERNATIONAL BUYERS
ALL TAXES, DUTIES AND LOCAL FEES AT THE DESTINATION COUNTRY WILL BE PAID BY BUYER. OUR SHIPPING COST INCLUDE DELIVERY TO A DESTINATION ADDRESS ONLY. ALL GLOBMARBLE PRODUCTS ARE SHIPPED FROM THE UNITED STATES